The third generation in the Tree Austria Series offers movable leg loops for greater mobility.
Sit-board and shoulder straps can be fitted with ease. Air channels in padding allow for better air circulation. The large side D-rings are for lanyard positioning.
More comfort and a better load distribution is achieved by running the waist section, leg loops, and bridge through just one ring.
The measurement for the harness size correlates to the pelvic measure, not the waist. The measurement MUST be taken with tape measure around the rim of the hips, slightly above where a belt sits for most normal trouser wearers (not the waist). To be taken whilst wearing trousers and T shirt. Typically, this measurement is two inches larger than your jeans waist measurement. For example, I take a size 36″ waist in Jeans, but my pelvic rim measure is 38″ and my hips are 40″. Clothing layers need to be considered, so if the client is just inside the upper limit, they will be better off with the next size up.
It is very important to ensure the correct waist size, to ensure the hip D’s sit in the correct position, and sufficient room for adjustment is possible between summer and winter clothing:
Meets standards EN 813, EN 358 and ANSI A10.14-1991.
The Tree Austria 3.2 Harness is available in 2 sizes
- Size 1 – Medium – 30″ to 41″
- Size 2 – Large- 34″ to 45″